| Part No | Manufacturer | Application |
|---|
| MAX6320PUK36DY-T | MaximIC | "Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.600V, reset timeout(min) 1.12sec, watchdog timeout(typ) 1.6sec" |
| OP27EZ | MaximIC | Low-noise precision operational amplifier. 8MHz gain-bandwidth product. 2.8V/micros slew rate |
| MXD1005SE175 | MaximIC | 5-tap silicon delay line |
| MAX9053AEUB | MaximIC | "Micropower, single-supply, dual comparator + precision reference IC." |
| MAX232CPE | MaximIC | "+5V-powered, multichannel RS-232 driver-receiver." |
| ICM7217CIPI | MaximIC | 4 digit (LED) presettable up/down ciounter |
| MAX853ESA | MaximIC | "Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 1mVp-p output voltage ripple. 100kHz charge-pump switching frequency. Logic-level shutdown mode 1microA max over temp." |
| DG381BWE | MaximIC | General purpose CMOS dual analog switch. |
| MAX529CWG | MaximIC | "Octal, 8-bit, serial DAC with output buffer. Single +5V or dual +-5V supply operation." |
| MAX3222ECUP | MaximIC | "+-15kV ESD-protected, down to 10nA, 3.0V to5.5V, up to 1Mbps, true RS-232 transceiver." |
| MAX420MTV | MaximIC | +-15V chopper stabilized operational amplifier. |
| MAX4554EPE | MaximIC | "Force-sense switches (two force switches, two sence switces and two guard switches configured as two 3PST NO switches)." |
| MAX545ACSD | MaximIC | "+5V, serial-input, voltage-output, 14-bit DAC. INL (LSB) +-1/2" |
| MAX6314US29D4-T | MaximIC | 68H11/bidirectional-compatible microprocessor reset circuit. Reset threshold(nom) 2.93V. Reset timeout period(min) 1120ms. |
| MX7837BR | MaximIC | "Complete, dual, 12-bit multiplying DAC. 8-bit + 4-bit interface. Error (LSB) +-1/2" |
| MX7537SQ | MaximIC | CMOS parallel loading dual 12 bit multiplying D/A converter. Gain error +-6 LSB. |
| MAX4051MJE | MaximIC | "Low-voltage, CMOS analog multiplexer" |
| DG411CY | MaximIC | "Improved, quad, SPST analog switches" |
| MAX4242ESA | MaximIC | "Dual, ultra-low-voltage operation guaranteed down to +1.8V, typical operation to +1.5V, 10microA supply current, Beyond-the-Rail op amp." |
| MAX1686HEUA | MaximIC | 3V to 5V regulating charge pump for SIM cards. |
| MAX6320PUK49AZ-T | MaximIC | "Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec" |
| MAX4074BFESA | MaximIC | "Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 25V/V, noninverting gain 26V/V, -3dB BW 106kHZ." |
| MX7531JCWN | MaximIC | CMOS 12 bit multiplying D/A converter. Error 0.2% |
| MAX6003EUR-T | MaximIC | "Low-cost, low-power, low-dropout, voltage reference. Output voltage 3.000V, input voltage (Vout+200mV) to 12.6V." |
| IH5144CJE | MaximIC | "Low power fast CMOS analog switch. Double pole, single throw (DPST)." |
| MAX4662CAE | MaximIC | "2.5om, quad, SWPST, CMOS analog switch (four NO switches)." |
| MAX339CSE | MaximIC | "Dual 4-channel, low-leakage, CMOS analog multiplexer." |
| MM74C945C/D | MaximIC | 4 digit up/down counter/decoder/driver. |
| MAX311EWN | MaximIC | "CMOS RF/video multiplexer (2-of-8, 4 channel differential)." |
| MAX6317HUK34AY-T | MaximIC | "Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.400V, min reset timeout 1ms, typ watchdog timeout 1.6sec" |
